It looks like you're new here. If you want to get involved, click one of these buttons!
I downloaded the 16.04 image from 3/9/2018, wrote it to the provided 16GB SD Card using etcher (what I use for my Pi 3 and TinkerBoard), hooked up a HDMI display that works with Pi and TinkerBoard and I get nothing. Normally you would see a bunch of messages as it boots up but I just get a blank screen.
All I can think of is try again a known good SD Card in case the SD Card is bad.
Should this image show the messages before launching the Desktop like Raspbian and TinkerOS?
Is there an expected sequence for the LED's that might indicate what is going wrong?